Happy New Year From Mississippi!
I have too much free play on my clutch pedal & the most likely suspect to me is a stretched cable, seeing how the clevis is tightened all the way up. So my question is can I change the cable without disassembling the clutch housing from the engine? I see the little ball on the end & so it must index to the release arm in a slot but I can't see up in there. The TM is not clear about how to service this part.
Also there is no stay cable installed on this Jeep, I have both cables new. Thanks!
PS- I have no idea where these photos came from!
Clutch Cable Question
-
- Sergeant Major of the Gee
- Posts: 472
- Joined: Tue Apr 19, 2005 3:48 pm
- Location: Central Mississippi
-
- G-Sergeant Major
- Posts: 150
- Joined: Sun Dec 16, 2018 9:43 pm
- Location:
- Contact:
Re: Clutch Cable Question
I’ve never seen a cable stretch to the point of unable to adjust it. Normally the disk itself will wear thin and that will change the fork angle which requires you to adjust cable. I’d bet your about worn out on the disk.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
Jim Nissen
1955 M38A1
Patent Plate MD74784
Engine Plate MD85578
BS Hood Number 20974784
1955 M38A1
Patent Plate MD74784
Engine Plate MD85578
BS Hood Number 20974784
-
- Sergeant Major of the Gee
- Posts: 472
- Joined: Tue Apr 19, 2005 3:48 pm
- Location: Central Mississippi
Re: Clutch Cable Question
Thanks.
But if the disc wears thin, won't that make the pressure plate release levers run High, thereby Reducing Free Play?
My problem is the other way round.
But if the disc wears thin, won't that make the pressure plate release levers run High, thereby Reducing Free Play?
My problem is the other way round.
-
- G-Sergeant Major
- Posts: 150
- Joined: Sun Dec 16, 2018 9:43 pm
- Location:
- Contact:
Clutch Cable Question
Have you checked the bushings for the linkage. If something slipped or worn that certainly can increase slop. You can always remove the access panels and inspect the cable and clutch if your avoiding pulling the motor or dropping the trans/ case.
BTW yes you can carefully replace a cable without taking everything apart. I had a cable slip in assembly and just fished it back in via the hole and the bell housing access plate. Took a long reach needle nose and nimble fingers but got it back on.
Sent from my iPad using Tapatalk
BTW yes you can carefully replace a cable without taking everything apart. I had a cable slip in assembly and just fished it back in via the hole and the bell housing access plate. Took a long reach needle nose and nimble fingers but got it back on.
Sent from my iPad using Tapatalk
Jim Nissen
1955 M38A1
Patent Plate MD74784
Engine Plate MD85578
BS Hood Number 20974784
1955 M38A1
Patent Plate MD74784
Engine Plate MD85578
BS Hood Number 20974784
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: Clutch Cable Question
How long is your clutch cable?
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
-
- Sergeant Major of the Gee
- Posts: 472
- Joined: Tue Apr 19, 2005 3:48 pm
- Location: Central Mississippi
Re: Clutch Cable Question
The new one or the old one?
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: Clutch Cable Question
Both.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
Who is online
Users browsing this forum: No registered users and 40 guests