M Series Modification (DISTRIBUTOR)

M151 modifications, sugestions, and ideas, official MWO's and unofficial field mods

Post Reply
User avatar
lten1063
G-Colonel
G-Colonel
Posts: 1846
Joined: Fri Apr 01, 2005 7:34 pm
Location: GERONIMO, OKLAHOMA-USA

M Series Modification (DISTRIBUTOR)

Post by lten1063 » Thu Sep 14, 2017 4:58 pm

This Modification will allow one to run civilian Plug Wires & Spark Plugs off of the original 24V Distributor. Cut to the length per cylinder. You will need to trim a bit off from the outer shield of the end that fits into distributor. Select the boot you desire. Will need to push in as far by hand then drive on home by taping it in with a small hammer and a small pocket flat tip screw driver.
Note: if you have a spare housing and cap you can revert back if you want.
Parts needed:
1 set of plug wires -
OMNI SPARK / 9998
Available @
O'REILLY

1 set of spark plugs-
ACDELCO / R43S
Available @
O'REILLY

1 set of Distributor Wire Terminal Ends
Motorcraft / 5301
Available @
https://www.ebay.com/p/10-Pices-Brass-S ... 2127369309

Later Joe
"Apply The 5 "P" theory" (Previous Planning Prevents Poor Performance)"
"When something becomes FUBAR We Blame it on SNAFU Then Try to SWAG Our Way Out of it"
"My Wooden Nickels Worth"
"If ur Running Late, slo down & Walk Early next X"

Post Reply

Return to “M151 Modifications”

Who is online

Users browsing this forum: No registered users and 1 guest