Hi All,
I'm installing the harness in GP15116 and have been scouring the web looking for good photos of how the harness is routed. Long story short, I'm coming up short on how in detail the taillight harness is run along the frame and how it routes up to the junction on the firewall. My repro gas pedal came with a clip, does this clip hold the taillight harness as it exits the frame rail? I'm also curious about how the gas tank sender wire is routed up to the tank, does it use the same hole as the fuel line coming from the tank? If anyone has some good photos I and probably others would love to see them.
Thanks everyone
GP harness routing questions.
Moderator: DavidA
-
- G-Command Sergeant Major
- Posts: 234
- Joined: Sat May 05, 2007 12:07 pm
- Location:
- Rory Grenier
- G-Lieutenant Colonel
- Posts: 1073
- Joined: Fri Dec 13, 2002 4:23 pm
- Location: Grand Forks, ND USA
- Contact:
Re: GP harness routing questions.
Fuel tank sender wire should come up through the floor by its own hole. the hole should be under the fuel tank mud shield.
I will try to upload pictures this week.
Rory
I will try to upload pictures this week.
Rory
Rory Grenier
fordgpparts@gmail.com
Rory's Parts page http://www.ndmvca.com/joes-motorpool-page-1.html
MVPA #26108
fordgpparts@gmail.com
Rory's Parts page http://www.ndmvca.com/joes-motorpool-page-1.html
MVPA #26108
-
- Sergeant Major of the Gee
- Posts: 406
- Joined: Sun Apr 27, 2003 1:23 pm
- Location: somerset U.K.
Re: GP harness routing questions.
Fuel sender wiring hole is 1/2" diameter.
See not so good photo's - have put measurements on.
Hope they are good enough for you.
Pete
See not so good photo's - have put measurements on.
Hope they are good enough for you.
Pete
-
- G-Command Sergeant Major
- Posts: 234
- Joined: Sat May 05, 2007 12:07 pm
- Location:
Re: GP harness routing questions.
Thanks a million for the pics Pete! Those helped out a ton.
Who is online
Users browsing this forum: No registered users and 17 guests