winch storage and engine heat

1950 - 1968, M38, M38A1, M170, modifications, sugestions, and ideas, official MWO's and unofficial field mods.
Post Reply
teach
G-Civilian
Posts: 2
Joined: Thu Jan 26, 2017 4:29 pm
Location:

winch storage and engine heat

Post by teach » Sat Feb 04, 2017 8:46 pm

For my M38A1, I'm thinking about storing a 5,000 lb winch (can't justify a larger one for the limited amount I might need it and the extra weight) mounted on a piece of 2" tube inside my engine compartment, down low on the passenger side, just inside the fender wall. I have plate about 12"x12" down near the bottom of the engine on this side with nothing on it, not sure of its original purpose. This would be a nice spot to mount a piece of receiver to accept the 2" tube on the winch, then I could just hold it in place with a pin until I needed it. This way it is out of the way, and it will stay dry. This gives me the ability to use the winch on front or rear of jeep as needed with some quick connects. However, I am concerned that heat from the engine might have a negative impact on the winch. The engine is a 4cyl. F-head. What do you folks think? I appreciate any input.
Teach


Post Reply

Return to “M38, M38a1 Modifications”

Who is online

Users browsing this forum: No registered users and 5 guests