I need a photo or measurements of the metal piece which pivots the radiator louvers open and closed. It attaches below the hood by the radiator and on the rod which goes back into the cab. I hope that makes sense. The stud it pivots on is still there so I could reverse engineer something but I would bet someone smarter than me has one or has already made one.
Any help with measurements or a photo would be appreciated... Thanks... Ed
M3a1 Scout Car Louver Pivot Question
-
- G-Sergeant
- Posts: 38
- Joined: Wed Jun 16, 2021 6:09 am
- Location: Ohio
-
- G-Major General
- Posts: 3039
- Joined: Wed Mar 05, 2003 6:22 pm
- Location: Florida
Re: M3a1 Scout Car Louver Pivot Question
I think that is called a bell crank but not sure. I'll check and see if it is the same as the halftrack, i think it is identical. If so that should make it a little easier to find.
Green Trucks and High Tides Forever
Diamond T M3 Half-track Serial # M32971 USA 4045956
Autocar M3A1 Half-track Serial # M3A1-47825 USA 4053835
Autocar M16A1 Half-track Serial # M15A1-1945 USA 40150662
Diamond T M3 Half-track Serial # M32971 USA 4045956
Autocar M3A1 Half-track Serial # M3A1-47825 USA 4053835
Autocar M16A1 Half-track Serial # M15A1-1945 USA 40150662
Who is online
Users browsing this forum: No registered users and 42 guests