Page 1 of 1
WTB early carburetor base
Posted: Sat Aug 01, 2020 2:40 pm
by wheeeeler
Looking for a early base for a 3-42 GPW2135
Re: WTB early carburetor base
Posted: Tue Aug 11, 2020 6:36 pm
by Jonathan
Good day,
What constitutes "early"?
Whatvare the differences?
Re: WTB early carburetor base
Posted: Wed Aug 12, 2020 6:38 am
by Michael O.
Jonathan wrote: ↑Tue Aug 11, 2020 6:36 pm
Good day,
What constitutes "early"?
Whatvare the differences?
I’m not aware of any. The “407” flange was the same throughout production as far as I know.
Re: WTB early carburetor base
Posted: Wed Aug 12, 2020 3:55 pm
by Jonathan
I didn't THINK there were early/late bases.
May be some small variation at some point but I'm not aware either.
Re: WTB early carburetor base
Posted: Thu Aug 13, 2020 2:06 am
by Scoutpilot
The difference is the early ones had no vacuum port. The later ones did.
Re: WTB early carburetor base
Posted: Thu Aug 13, 2020 4:33 am
by Jonathan
Thank you Scout!
Re: WTB early carburetor base
Posted: Thu Aug 13, 2020 2:09 pm
by Ron Fitzpatrick
Re: WTB early carburetor base
Posted: Fri Aug 14, 2020 6:27 am
by Michael O.
Scoutpilot wrote: ↑Thu Aug 13, 2020 2:06 am
The difference is the early ones had no vacuum port. The later ones did.
Would the ones with a vacuum port be a 596 or a 636 flange?
Re: WTB early carburetor base
Posted: Fri Aug 14, 2020 8:23 am
by Scoutpilot
I have encountered both without a vacuum port. Most do.
Re: WTB early carburetor base
Posted: Mon Aug 17, 2020 1:45 am
by wo2jeeper
Scoutpilot wrote:The difference is the early ones had no vacuum port. The later ones did.
On a GPW carb or are you talking about the generic W0 carb....