WTB: MB Exhaust Manifold

[Michael O.]

Looking for an MB exhaust manifold with A 659 marked on the front face as shown and without the dimples on the arms. Thanks in advance!

[Joe Gopan]

Whose Jeep does this manifold go to?

[Michael O.]

It’s a photo someone sent me...just re-used it as a representation of what I’m looking for.

[Joe Gopan]

I noticed the "split" lockwasher, they best not be used on exhaust manifolds, the high heat causes them to lose their temper.

[JerryKans]

I have one with those markings. PM or e-mail me if you would like photos to verify it is what you need. I'm not quite sure on the dimples you were referring to. Thanks.

[Michael O.]

PM sent...thank you for checking.

[Michael O.]

Here’s one installed on an early MB motor. Notice, there are no dimples (aka nipples) on the arms.

[Joe Gopan]

best chance to see a vintage exhaust manifold is on a WWII vintage PE-95. Many are still intact.

[Michael O.]

Again, looking for one like this with no nipples on the arms.

[Joe Gopan]

And you are checking out PE-95's?

[Richard Grace]

PE95s usually have smaller runners.....-RG

[Joe Gopan]

Yes, on the intake, but not on the exhaust portion which is the same part as om MB and CJ2A, etc..

[Richard Grace]

Michael, PM sent.......-RG

[Michael O.]

Thanks Richard...replied to your PM.

[Joe Gopan]

I'll look at my PE-95 one to see if it matches your description.