Magneto oil line?
-
- G-Corporal
- Posts: 25
- Joined: Mon Mar 08, 2021 4:51 pm
- Location: Maryland
Magneto oil line?
I am trying to install a rebuilt Emery Mule Supply magneto and am stumped by one of its fittings, the one with the red cap in the picture. I have looked at the figures and instructions in TM 5-2805-213-14 and it is not mentioned. Figure 3-15 doesn't seem to show it either. The mule is a 1968 A5 with the wide fender conversion. It came with an electronic ignition magneto and I am replacing it with a standard magneto. The old magneto did not have this fitting. My other mule has the fitting and tube but it is 2 hours away, so I was hoping someone could help me figure out where this fitting is supposed to hook up to.
-
- G-Lieutenant General
- Posts: 5820
- Joined: Wed Dec 18, 2002 11:00 am
- Location:
Re: Magneto oil line?
That's just a vent line, should run over to a fitting on top of the air filter canister.
On the electronic mag, the vent line was not used and the mag had a plug in it. Not sure about the air filter, it may also be plugged, or you may have to drill and tap, can't remember!
On the electronic mag, the vent line was not used and the mag had a plug in it. Not sure about the air filter, it may also be plugged, or you may have to drill and tap, can't remember!
-
- G-Corporal
- Posts: 25
- Joined: Mon Mar 08, 2021 4:51 pm
- Location: Maryland
Re: Magneto oil line?
Chuck, thank you so much!!!
Who is online
Users browsing this forum: No registered users and 37 guests