No, the trans rubber mount is a couple inches farther back.Hell On Wheels wrote:I just mounted my transmission does it use the same transfer cross member support?
Sent from my iPad using Tapatalk
4L80-E Conversion
Moderator: Kurt Lesser
-
badgerd
- G-Corporal
- Posts: 17
- Joined: Sat Aug 31, 2019 3:36 pm
- Location:
Re: 4L80-E Conversion
Sent from my iPad using Tapatalk
-
Hell On Wheels
- G-Colonel
- Posts: 1530
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: 4L80-E Conversion
What NSN are used for the below?
A2 Front Drive Shaft (Only the section between the slip joint and the T-Case) (Alternatively, lengthen the existing shaft by 2? inches)
A2 Rear Drive Shaft (Shortened 7/8" if you plan to keep the drive shaft parking brake)
A2 Front Drive Shaft (Only the section between the slip joint and the T-Case) (Alternatively, lengthen the existing shaft by 2? inches)
A2 Rear Drive Shaft (Shortened 7/8" if you plan to keep the drive shaft parking brake)
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
Who is online
Users browsing this forum: HoveringHMMWV and 32 guests