Does anyone know what size connectors fit the two male bullet connectors on the brake signal switch on top
of the master cylinder.
All I had at the moment was a 10 gauge AWG connector and that was too small.
I assume that is what is used?
Thanks
1/2 ton WC brake signal lamp switch question
-
- G-Corporal
- Posts: 26
- Joined: Wed Apr 20, 2016 11:10 am
- Location:
- 17thAirborne
- G-Lieutenant General
- Posts: 5847
- Joined: Mon Jun 21, 2004 5:42 am
- Location: Central TN
Re: 1/2 ton WC brake signal lamp switch question
have you found a suitable connector? i'm almost at that point in my wiring. i am thinking the ends on the switch are the same as the male bullet connectors used in splices. my plan was to use two of the female bakelite connectors to make the connection. the Tm does not show or list the part details.
Oz
Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)
Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)
- 17thAirborne
- G-Lieutenant General
- Posts: 5847
- Joined: Mon Jun 21, 2004 5:42 am
- Location: Central TN
Re: 1/2 ton WC brake signal lamp switch question
Brake Terminals. I used the plastic covered female connectors, stripped off the hard plastic and soldered them on to the wires and covered with shrink wrap. It looks more period than with the blue coating.
Oz
Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)
Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)
-
- G-Corporal
- Posts: 26
- Joined: Wed Apr 20, 2016 11:10 am
- Location:
Re: 1/2 ton WC brake signal lamp switch question
I never heard back from anyone, I ended up calling Jens at VPW.
He had the connectors in stock and sent me the two I needed.
Looks like your method works just as well.
Keep up the good work...
He had the connectors in stock and sent me the two I needed.
Looks like your method works just as well.
Keep up the good work...
- 17thAirborne
- G-Lieutenant General
- Posts: 5847
- Joined: Mon Jun 21, 2004 5:42 am
- Location: Central TN
Re: 1/2 ton WC brake signal lamp switch question
If you get a chance, post an image of the connections
Oz
Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)
Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)
Who is online
Users browsing this forum: No registered users and 42 guests