Converto Pivot Pin Dimensions

Half-ton trailer series and larger, Wanted, For Sale(NO EBAY ITEMS), and Knowledge Base
Post Reply
User avatar
17thAirborne
G-Lieutenant General
G-Lieutenant General
Posts: 5847
Joined: Mon Jun 21, 2004 5:42 am
Location: Central TN

Converto Pivot Pin Dimensions

Post by 17thAirborne » Sat Oct 23, 2021 5:43 am

Posting for a friend and anyone else who can use this. My pin is somewhat beat up and rusty, so it looks like most of the measurements are in whole inches and multiples of 1/8 inches as you can see from what I measured with my calipers. The width of the pin varied depending on where I took the measurements. It could be 1" but so could the hole in the frame and bed with the pin being a few thou less. You decide.

I did not measure the diameters of the two cotter pin holes.
converto pin1.jpg
Oz

Feb 43 GPW 98532 USA 20206257
Oct 70 Land Rover Series 2a 25334079G NZ16GF36
http://gpw.castraponere.com/ (My Restoration Page)


Post Reply

Return to “Trailers 1/2 ton +”

Who is online

Users browsing this forum: No registered users and 51 guests