Chev 1 1/2 ton exhaust

[Hanselandgretel]

Does anybody have a NAPA or similar number for the exhaust pipe (manifold to muffler)? I'd rather buy a factory one than a custom made one. Thanks

[retro-roco]

The exhaust and tail pipes are unique to the G506 trucks.

[kelley]

Hello Al,
This is How I made my down pipe…
Go to this thread and take a look… viewtopic.php?f=25&t=299837 it’s about 5 pages in.
I found a seller on eBay who bends/forms exhaust pipe. I explained what I was doing and he happily made me up an assortment of elbows, male and female ends, straight pieces and manifold adapters. If you’re not able to weld them together, you could simply cut and duct tape them together until you get it close and then get someone to tack them together enough to dry fit. It might take a few tries, but you’ll get it.
I hope this helps.

[Hanselandgretel]

Thanks for your thoughts. I'm working on it.