Page 1 of 1

G102 Half Track Front Axle parts request

Posted: Thu Oct 24, 2019 6:44 pm
by pintelhook11over
Hello everyone, I'm finally getting into helping out at the local museum motor pool and there are some old "Veterans" that need A lot of TLC.

The half-track is closest to the shop, the engine is out and the right/front is disassembled with a chewed up spindle...

Anybody in southern california have any front axle parts?

The way it looks to me is to re-tube the short side of the front axle or swap out a right side axle housing. It looks like its been apart for some time.

Image
Image

Re: G102 Half Track Front Axle parts request

Posted: Thu Oct 24, 2019 7:10 pm
by pintelhook11over
Data plate by glove box area is illegible except for stamped numbers in metal

Data plate:

line 1--329725 MFG. serial?
line 2--297254 Ord. serial?

line 3-- 40 max MPH?
line 3.5--3000 Max Rpm?

line 4-- G102?
line 5-- TM 9-710?
line 6--TM 9-1710, 1710, 1711

Re: G102 Half Track Front Axle parts request

Posted: Thu Oct 24, 2019 9:36 pm
by pintelhook11over
Maybe the spindles come off like a smaller G506/G508?

Re: G102 Half Track Front Axle parts request

Posted: Fri Oct 25, 2019 11:17 am
by yd328
You can replace that spindle seperatley from the axle. You have to remove the backing plate and it should seperate.

Gary

Re: G102 Half Track Front Axle parts request

Posted: Fri Oct 25, 2019 12:36 pm
by coreyelliott
As Gary said, you can replace that spindle separately from the axle. In the two pictures below you can see where we had ours disassembled and you can see the spindle among the other parts.


Image


Image


Corey

Re: G102 Half Track Front Axle parts request

Posted: Sat Oct 26, 2019 4:46 am
by JrPartsCo
I have a spindle in stock along with a huge NOS parts inventory and reproduction parts
JRPARTSCOMPANY@GMAIL.COM
PH OR TEXT 815-293-0958

Re: G102 Half Track Front Axle parts request

Posted: Mon Oct 28, 2019 11:33 am
by pintelhook11over
Hello,

Thank you for the response, I called the landline on 10-28-19, left my number with Mr. H Senior to pass on my phone number new shop leadership to get a estimate for 1 or 2 spindles for a G102.

Shipping would be to zip 91710 Chino, CA

I don't have authorization for billing yet, but am trying to perform parts expedite process for submission and approval.

Thanks in advance :D