I have a GP7091 propeller/driveshaft that is shorter that the ones for my GPW. Was the GPA shaft the same length as the GPW? The one I have is approximately 17 1/2" from center to center. It's like brand new and doesn't appear to be a bubba job.
Thanks
Ron
GP Driveshaft/Propeller Question
-
- G-Master Sergeant
- Posts: 104
- Joined: Sun Jun 19, 2016 4:08 pm
- Location: NE Oklahoma
GP Driveshaft/Propeller Question
1942 Ford GPW Script
1943 Willys MB
1943 Willys MB
-
- G-Major
- Posts: 999
- Joined: Mon Jun 02, 2003 2:11 pm
- Location: Orange County, CA
Re: GP Driveshaft/Propeller Question
Ron,
My understanding is that the rear driveshaft on a GPA is the same as a GPW (same part no.). The front drive shaft has a GPA prefix so is not the same as a GP. I cannot measure mine as it is installed and I cannot measure without a lift to get it off the ground.
While the GPA does share some of the same parts as a GP (spring shackles that I recall), most drive train parts are the same a a GPW.
Donovan.
My understanding is that the rear driveshaft on a GPA is the same as a GPW (same part no.). The front drive shaft has a GPA prefix so is not the same as a GP. I cannot measure mine as it is installed and I cannot measure without a lift to get it off the ground.
While the GPA does share some of the same parts as a GP (spring shackles that I recall), most drive train parts are the same a a GPW.
Donovan.
GPA 11374
Who is online
Users browsing this forum: No registered users and 47 guests