Great MOD for adding front TURN and DAY RUNNING lights - 3D

1945 - 196*, Willys CJ series, questions, discussions, regarding anything related to the post war jeep.®
Post Reply
diegux
G-Civilian
Posts: 1
Joined: Thu May 19, 2022 9:33 am
Location: Buenos Aries

Great MOD for adding front TURN and DAY RUNNING lights - 3D

Post by diegux » Fri May 20, 2022 3:50 am

Hello from Argentina my friends !!!
Today I will share with you my 3D printing work for adding DRL and Turn lights.

I started with these Acco covers only
I will use the clear lens as DRL and will modify the blackout lens for turning signal

Image

Image

Then you will need some dotted or triangle/piramid pattern acrylic

Image
Image
Image
Image
Image
Image

At this point you will need the 3D part that I designed with Fusion 360
Image
Image
Image
Image
Image

Now you will need some low profile lights
I used a 6 white-led board for DRL and an amber led light for the turn signal
Image
Image

Now the new screws
I needed shorter screws than the originals.... and I just used 2 long screws for holding
Image

Note that you will need to make some holes in the 3D part to bring the cables out.
I did not add the holes in the Fusion 3D design so that you can make them depending on the led lights/cables you use
Image

This is my jeep:
Image

This is where I will place the lights:
Image

I you are interested in this mod and want the 3D part I will be more than happy to share with you the .stl file
I only will ask $5 to support my work and continue to invest time in new 3D parts for our jeeps Wink
Thanks for watching !!!

Diego.


Post Reply

Return to “CJ Technical Knowledge Base”

Who is online

Users browsing this forum: No registered users and 18 guests