Hello there, as I tore into the rear wiring I decided to replace the tail lights and ordered what I thought was the right replacements from Bensinger.(only received pass. side so far)
I think the manual shows 3 wire on drivers side and 2 wire on the passengers side, but mine are 3 wire on both sides.
The ones I removed were stamped 24V on the back, but I think they were modified as this Mite had a different engine and 12V lighting.
Any ideas what the old ones are?
Thanks in advance.
Tail light identification
- mytmight
- G-Corporal
- Posts: 29
- Joined: Fri Jul 13, 2018 2:18 pm
- Location: United States of America!
- Bill H.
- G Moderator
- Posts: 6246
- Joined: Sun May 31, 1998 8:00 pm
- Location: Yonna Valley, Oregon
Re: Tail light identification
Someone may have put two service stop lights on it. The picture #2 shows the correct doors with service stop on the left and blackout stop on the right. I've seen service stops on both left and right for higher visibility.
Bill H.
"Each shall seek his own kind, in other words, a bird may love a fish but where would they build a home together?" Tevye, Fiddler on the Roof
1952 Dunbar Kapple M100
1953 Willys M38A1
1962 AMC M422A1
1965 Stevens M416B1 X 2
1967 Kaiser M715
2 Timothy 3:1-5
"Each shall seek his own kind, in other words, a bird may love a fish but where would they build a home together?" Tevye, Fiddler on the Roof
1952 Dunbar Kapple M100
1953 Willys M38A1
1962 AMC M422A1
1965 Stevens M416B1 X 2
1967 Kaiser M715
2 Timothy 3:1-5
Who is online
Users browsing this forum: No registered users and 28 guests