I lost all my previous pictures from disassembly and the manual does not state which way the machined slots or broaching side faces during assembly in between the driven gear and the axle gear?If I remember right, they were facing inboard?
What is the correct installation. Is that machined end for oil distribution or something else?
DG IDLER GEAR QUESTION
-
- G-Master Sergeant
- Posts: 120
- Joined: Tue Feb 06, 2018 12:59 pm
- Location:
DG IDLER GEAR QUESTION
- Attachments
-
- IMG_0051.jpg (98.85 KiB) Viewed 2825 times
-
- IMG_0049.jpg (104.44 KiB) Viewed 2825 times
-
- IMG_0048.jpg (110.33 KiB) Viewed 2825 times
-
- G-Lieutenant General
- Posts: 5820
- Joined: Wed Dec 18, 2002 11:00 am
- Location:
Re: DG IDLER GEAR QUESTION
I don't know if it really matters, but I always put it towards the outside.
-
- G-Master Sergeant
- Posts: 120
- Joined: Tue Feb 06, 2018 12:59 pm
- Location:
Re: DG IDLER GEAR QUESTION
Thanks Chuck for the help and reply. I managed to find one of the pictures on here that I previously posted and you are correct, grooves or slots are facing outside towards the tire side.
Who is online
Users browsing this forum: No registered users and 32 guests