Interesting read on test report when the MUTT transitioned from 151 suspension to 151A2 design. Lots of other mods came in and it summarizes a lot of issues with everything from differentials, suspension cracks, frame cracks, etc. Mentions attempt to use a dual master cylinder also.
289 pg report here:
https://archive.org/details/DTIC_AD0857 ... 4/mode/1up
Here's one about oil duration using a MUTT as a test bed with special low oil consumption oil rings by TRW.
https://archive.org/details/DTIC_ADA023 ... 3/mode/1up
There was another I found using that search site which covered bias VS radial tires and warned to never mix any on a MUTT, it starts a severe oscillation.
V/R W Winget
Edit:
Rear Solid axle tests about 60 pgs:
https://archive.org/details/DTIC_AD0810 ... 7/mode/2up
Maintenance free ignition system:
https://archive.org/details/DTIC_AD0878259
Movie on MUTT 4 Cly engine removal, step by step:
https://archive.org/details/gov.dod.dimoc.29940
Life expectancy of the MUTT 160 pgs
https://archive.org/details/DTIC_AD0804868
There's more I'm sure.
Some MUTT Technical reports
- W. Winget
- LTC, U.S. Army
- Posts: 4445
- Joined: Mon Dec 16, 2002 10:37 am
- Location: USA, Virginia, Carrollton
- Contact:
Some MUTT Technical reports
Looking for 1918 Standard B 'Liberty' truck parts
-
- USMC Sergeant
- Posts: 946
- Joined: Sat Jun 13, 2009 12:44 pm
- Location:
Re: Some MUTT Technical reports
The info is too small to read, so maybe my computer is too old/defective
change user name to mark
- W. Winget
- LTC, U.S. Army
- Posts: 4445
- Joined: Mon Dec 16, 2002 10:37 am
- Location: USA, Virginia, Carrollton
- Contact:
Re: Some MUTT Technical reports
The info you see after a search is just the cover letter. It represents the document, which you should "right click and open in a new Tab" Then a .PDF file or movie will open in that new tab which you can read, save, flip through, etc.
I had them open to full single page, fully readable, but sometimes the phots are nothing but black blurbs due to the scanning process and the fact the scanners did not care to preserve the document, just doing a job...
V/R W Winget
I had them open to full single page, fully readable, but sometimes the phots are nothing but black blurbs due to the scanning process and the fact the scanners did not care to preserve the document, just doing a job...
V/R W Winget
Looking for 1918 Standard B 'Liberty' truck parts
-
- USMC Sergeant
- Posts: 946
- Joined: Sat Jun 13, 2009 12:44 pm
- Location:
Who is online
Users browsing this forum: flaminfiero, james larry loyd and 39 guests