Crossbar length on Woods Handcart

[Andy Cole]

I am wrapping up the mechanical part of restoring (well....conserving and preserving) my M3A4 Handcart.
Can someone tell me the total length, end to end of the crossbar/pull bar?

Thanks!
Andy

[Craig Johnson]

Here ya go. It's from a steel M3A4. I have found subtle differences of about 1/4 inch in length of pipe on others I own.

Sent from my SM-G996U using Tapatalk

[Craig Johnson]

Length of pipe.


Sent from my SM-G996U using Tapatalk

[Andy Cole]

Thanks!
I must have called the part I need by the wrong name.
I need the pull handle, drawbar..that pins on the lunette and or the aluminum block on the front of the cart.
The tubing with the hole and pin in the center.

Can you get me that measurement as well?
I am sorry for the confusion.

Andy

[Craig Johnson]

No. Looking back you were right and I was only into my first cup off coffee. Will post in a few of drawbar.

[Craig Johnson]

If you just need total length, it's 34" measured from an original.

Sent from my SM-G996U using Tapatalk

[Andy Cole]

Thanks!
That's All I needed. Length of bar, end to end.
34"
I can go cut my pieces now!

You are awesome!