Page 1 of 1

Parting a PU58 Prices Edited

Posted: Fri Aug 10, 2018 12:04 pm
by wadefreedomvehicles
I am keeping some parts for myself.
But most of it is for sale.
Side covers I am keeping, oil filter canister, generator(on engine), Panel cover, Pully off governor.

Engine with no oil filter or generator. Engine in unkown condition. Probably needs rebuilt. I believe it is a DJ3 Engine. (has recently redone starter) $200
Generator $100
Radiator $100
Panel(gauges, etc) $100
Fuel tank $50
Air filter $75

The generator was built into a trailer and air compressor unit. Whatever is left after part out Will be scrapped.
All parts are OBO. If a part is not listed you can ask about it.
Link to photos:
https://photos.app.goo.gl/TxH5MELFNjPSb6LF7

Re: Parting a PE95 Prices Edited

Posted: Sat Aug 18, 2018 10:35 pm
by Adam
Looks like a PU58 not a PE95, Whats the VR under the cover look like?

Do you have a side view picture of the intake?

Adam

Re: Parting a PE95 Prices Edited

Posted: Wed Aug 22, 2018 7:45 pm
by wadefreedomvehicles
Voltage regulator, Where is that found?

Re: Parting a PU58 Prices Edited

Posted: Wed Aug 29, 2018 11:56 am
by wadefreedomvehicles
Really would like to see these parts go somewhere rather than scrap.

Re: Parting a PU58 Prices Edited

Posted: Wed Aug 29, 2018 8:38 pm
by Adam
Look under that long cover on top of the generator right behind the engine held in by probably for flat head screws you say there was a generator mounted on the engine then without voltage regulator is under that cover

Re: Parting a PU58 Prices Edited

Posted: Thu Aug 30, 2018 8:26 am
by wadefreedomvehicles
Okay thanks.
And your thing about the generator makes no sense...

Re: Parting a PU58 Prices Edited

Posted: Thu Sep 06, 2018 9:56 am
by blitz67
I usually scrap out most of what is left too, there is just no demand for the parts, I have offered several parts on here over the years for free and as of yet, not one taker, not one. So scrap away

Re: Parting a PU58 Prices Edited

Posted: Thu Sep 06, 2018 9:57 am
by blitz67
But don't forget the voltage regulator, I had a PU-58 a couple months ago and almost missed it. Mine was like new.

Re: Parting a PU58 Prices Edited

Posted: Fri Sep 07, 2018 6:42 am
by Tim Shanteler
Are the small tabs (spring loaded) that are used to keep the panels in place available? I need a few.

Regards,

Tim

Re: Parting a PU58 Prices Edited

Posted: Tue Sep 11, 2018 10:36 am
by wadefreedomvehicles
Tim yes they are. I can pull them off.

Re: Parting a PU58 Prices Edited

Posted: Tue Sep 11, 2018 10:41 am
by Tim Shanteler
Great! PM me what you want for them and how to pay.

Tim