SEAL

1950 - 1952, M38, questions, discussions, regarding anything related to the M38.
Post Reply
JMZ421
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 493
Joined: Sat Jun 02, 2012 2:21 pm
Location: N.E. Ohio

SEAL

Post by JMZ421 » Fri Jan 22, 2021 4:16 pm

If someone could chime in, on the sector seal for a M38; the new seal I want to install for the sector is FLUSH, maybe a hair lower than the casing.
I have a picture of the one I took out and it appears to have been flush also but I am not sure what the Army did years and years ago. Is this correct, to be flush?? I tried pushing down further but it will not go with causing a distortion. I was reading some posts from the G503, maybe the seal in the Ross for the M38 does not go down as far. The casing is a TA122985 Ross

Your thoughts, Thanks, John


JMZ421
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 493
Joined: Sat Jun 02, 2012 2:21 pm
Location: N.E. Ohio

Re: SEAL

Post by JMZ421 » Sat Jan 23, 2021 7:04 am

Found the answer on old Willys forum. Good to go. John

Post Reply

Return to “M38 Technical Knowledge Base”

Who is online

Users browsing this forum: No registered users and 5 guests