Carter YS carb port to crossover tube line. Necessary?

Post by **signsup** » Mon Mar 09, 2020 7:04 pm

That link may not work. Welcome to my world. This one may...

https://www.youtube.com/edit?o=U&video_ ... 3809046018

W. Winget · Post by **W. Winget** » Tue Mar 10, 2020 4:23 am

https://www.youtube.com/watch?v=jv7OjxR3wN0

You had too much info in the link, basically your creation link.
The above is the correct one.
V/R W Winget

PS Good Video WAW

Post by **RobertGallagher** » Sun May 10, 2020 2:49 pm

I had my YS carb rebuilt by a well known person who specializes in old Jeep carbs and I was never able to run my M38A1 with the crossover tube vent line installed. I bought a spare YS carb for comparison and found out that the check valve ball bearing and weight were missing. After my borrowed them from the spare and installed them in my rebuilt YS carb I could now hook up my vent line to the cross over tube and it runs great. Took me a year to figure it out

Joe Gopan · Post by **Joe Gopan** » Mon May 11, 2020 9:13 am

The Jeep should run perfect with those vent lines connected as in the TM/SNL photos. There is no reason not to. You need some help on site.

Joe Gopan · Post by **Joe Gopan** » Mon May 11, 2020 3:00 pm

Perhaps you have the Vent Line attached to a source of vacuum.

G503 Military Vehicle Message Forums

Carter YS carb port to crossover tube line. Necessary?

Re: Carter YS carb port to crossover tube line. Necessary?

Re: Carter YS carb port to crossover tube line. Necessary?

Re: Carter YS carb port to crossover tube line. Necessary?

Re: Carter YS carb port to crossover tube line. Necessary?

Re: Carter YS carb port to crossover tube line. Necessary?

Who is online