Spark Plug removal

Mighty Mite modifications, sugestions, and ideas, official MWO's and unofficial field mods

Post Reply
charlie baker
Posts: 1
Joined: Thu Oct 05, 2017 9:01 pm

Spark Plug removal

Post by charlie baker » Fri Oct 06, 2017 2:52 pm

I have undone the wires, but the remaining "plug" is too long for my Spark Plug Socket. is there a trick or a source for an XL socket???

User avatar
G-First Sergeant
G-First Sergeant
Posts: 127
Joined: Mon Jun 11, 2007 10:05 am
Location: N. Calif.

Re: Spark Plug removal

Post by mspeters » Sun Oct 08, 2017 11:26 am

Hi Charlie,

There is a stamped steel tool that several suppliers sell for shielded spark plugs

I use a deeply broached 1/2 drive deep socket, then adapt down to 3/8 ratchet. Snap-on works. Sunex doesn’t, broaching is not deep enough. In a pinch, i’d cut & weld two cheap sockets together.

Suggest you use copper washers on the plugs (same as included in the Mite’s gasket kits) in lieu of the steel seals on the plugs.
The copper washers fit & seal better around the steel spark plug inserts.

Post Reply

Return to “Mighty Mite Modifications”

Who is online

Users browsing this forum: No registered users and 1 guest