1941 - 1945, MB, GPW Technical questions and discussions, regarding anything related to the WWII jeep.
3 posts • Page 1 of 1
- Posts: 1330
- Joined: Sun Jan 11, 2004 4:37 pm
No picture, but is very simple, from drivers side of fuel gauge go left over the light switch and down to the hole in your left front gusset in side panel. From here back along the rail underneath and through the split in the top of the vertical reinforceing panel at the bend . The wire should be insulated all the way to the sender. Once through the split, it simply bends down and rests on the top of the tank going over to the sender. I ran a ground wire from the sender mounting screws to one of the three tin seat shield bolts behind the seat. The other side of the fuel gauge goes down to one of the two breakers. Hope this helps
Who is online
Users browsing this forum: Greendot319 and 4 guests