some gauges for sale.
-
- Sergeant Major of the Gee
- Posts: 362
- Joined: Tue Apr 19, 2016 9:19 pm
- Location: Australia
some gauges for sale.
Hi all
I am selling few gauges.
The GAS gauge and ampere gauges were off 42 slat jeep.
The Gas gauge I did some little work on, it work on sender unit and the face plate has been repaired,
The ampere gauges did some cleaning on bezel as the original paint was pealing off, it's a NOS.
The fuel gauges works on sender unit when tested. Correct for GBT ford, ford blitz, later Bren gun carrier,
Pictures
http://www.surfacezero.com/g503/data/44 ... ge2453.jpg
http://www.surfacezero.com/g503/data/44 ... ge2454.jpg
GAS gauge $100 SOLD PENDING
Amp gauge $80
Fuel gauge $45
Located Australia
Happy with friends and family PayPal.
Cheers Peter
I am selling few gauges.
The GAS gauge and ampere gauges were off 42 slat jeep.
The Gas gauge I did some little work on, it work on sender unit and the face plate has been repaired,
The ampere gauges did some cleaning on bezel as the original paint was pealing off, it's a NOS.
The fuel gauges works on sender unit when tested. Correct for GBT ford, ford blitz, later Bren gun carrier,
Pictures
http://www.surfacezero.com/g503/data/44 ... ge2453.jpg
http://www.surfacezero.com/g503/data/44 ... ge2454.jpg
GAS gauge $100 SOLD PENDING
Amp gauge $80
Fuel gauge $45
Located Australia
Happy with friends and family PayPal.
Cheers Peter
Last edited by Peterdodge6volt on Mon May 21, 2018 12:53 am, edited 1 time in total.
-
- G-Sergeant Major
- Posts: 155
- Joined: Wed Nov 28, 2007 6:01 am
- Location: Hampshire, UK
Re: some gauges for sale.
Hi Peter,
PM sent.
Cheers
PM sent.
Cheers
'41 Slat Grill 'Lucky Lucy'
'42 Chevy G506 Dump (non winch, Hercules bed) 'Oddball'
On the look out for any Slat parts!
'42 Chevy G506 Dump (non winch, Hercules bed) 'Oddball'
On the look out for any Slat parts!
- Chuck Lutz
- Gee Addict
- Posts: 26829
- Joined: Wed Jun 28, 2006 7:00 am
- Location: Jeep Heaven
Re: some gauges for sale.
I believe the gauge listed as for a G8T Ford truck is incorrect. Ford was using Stewart Warner gauges as can be seen here:
https://www.youtube.com/watch?v=u0wwv1khECM
https://www.youtube.com/watch?v=u0wwv1khECM
Chuck Lutz
GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
Bantam T3-C 1947
GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
Bantam T3-C 1947
-
- Sergeant Major of the Gee
- Posts: 362
- Joined: Tue Apr 19, 2016 9:19 pm
- Location: Australia
Re: some gauges for sale.
Arrhhh again I am blind reading my thread again I spelt GBT instead of GTB thanks chuck when I watch the video you post I said wait a minute that's not Burma jeep. And I read my thread realise I miss read the word the wrong way.
The later GTB Burma jeeps had them
The later GTB Burma jeeps had them
-
- Sergeant Major of the Gee
- Posts: 362
- Joined: Tue Apr 19, 2016 9:19 pm
- Location: Australia
Re: some gauges for sale.
Gas gauge sold.
Thanks G506
Thanks G506
Last edited by Peterdodge6volt on Mon May 21, 2018 12:54 am, edited 2 times in total.
- Chuck Lutz
- Gee Addict
- Posts: 26829
- Joined: Wed Jun 28, 2006 7:00 am
- Location: Jeep Heaven
Re: some gauges for sale.
Here is a GTB dash....made by Ford. Look at it this way, Stewart Warner was supplying Ford with the basic four gauges (plus speedo in some) for the jeep with the exception of some early 1942 jeeps AFAIK, and they certainly supplied them in all later GPWs....so again, I would wonder who it was that said the one you have was "correct"?
Chuck Lutz
GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
Bantam T3-C 1947
GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
Bantam T3-C 1947
-
- Sergeant Major of the Gee
- Posts: 362
- Joined: Tue Apr 19, 2016 9:19 pm
- Location: Australia
Re: some gauges for sale.
Hi Chuck
The picture you post are all repro gauges on the GTB panel
The early ones had long needle fuel gauges SW 1942 till late 1943,
Short needle fuel gauges SW they use in late 43 till mid March
The king seely fuel gauges was use mid March till mid Korea war.
Because they did not have enough short needle fuel gauges SW, so they use king seely fuel gauges.
And don't forget king seely gauges we're built by ford too.
I mentioned early last year when I post on someone post. That I had a friend a very close old friend who gave to me as a gives the book stories of his father and his grandfather during the war and Korea war, they were building military vehicles
And I had a lot of information about gauges, I went to check how many pages on the book and it has 87 pages of gauges in different year and ran out of stock of gauges and when was gauges change to different types brands and when was the Last gauges built.
And I am sorry I am not yet going to release the secrets yet of the book to this form. The book I have it's just gauges only.
Here is the picture of the mid 45
It's has the fuel gauges on it
http://www.surfacezero.com/g503/data/44 ... ge2455.jpg
Also if you write GTB Burma truck gauges on website images, I see so many pictures of GTB Burma on website have these fuel gauges on it.
Peter.
The picture you post are all repro gauges on the GTB panel
The early ones had long needle fuel gauges SW 1942 till late 1943,
Short needle fuel gauges SW they use in late 43 till mid March
The king seely fuel gauges was use mid March till mid Korea war.
Because they did not have enough short needle fuel gauges SW, so they use king seely fuel gauges.
And don't forget king seely gauges we're built by ford too.
I mentioned early last year when I post on someone post. That I had a friend a very close old friend who gave to me as a gives the book stories of his father and his grandfather during the war and Korea war, they were building military vehicles
And I had a lot of information about gauges, I went to check how many pages on the book and it has 87 pages of gauges in different year and ran out of stock of gauges and when was gauges change to different types brands and when was the Last gauges built.
And I am sorry I am not yet going to release the secrets yet of the book to this form. The book I have it's just gauges only.
Here is the picture of the mid 45
It's has the fuel gauges on it
http://www.surfacezero.com/g503/data/44 ... ge2455.jpg
Also if you write GTB Burma truck gauges on website images, I see so many pictures of GTB Burma on website have these fuel gauges on it.
Peter.
- Chuck Lutz
- Gee Addict
- Posts: 26829
- Joined: Wed Jun 28, 2006 7:00 am
- Location: Jeep Heaven
Re: some gauges for sale.
Hmmm....I'm not too sure they are not post-war replacements...
Here is an early GTB with the long needle Fuel & Amperes: Here is what I believe is a late GTB with the short needle Amperes and...the SW style Fuel gauge remnants: I have only seen a few GTBs around here but they usually are fitted with SW gauges .In addition, I have seen a couple wreckers that also have the short needle SW gauges in them but they were paintcan lid style.
Here is an early GTB with the long needle Fuel & Amperes: Here is what I believe is a late GTB with the short needle Amperes and...the SW style Fuel gauge remnants: I have only seen a few GTBs around here but they usually are fitted with SW gauges .In addition, I have seen a couple wreckers that also have the short needle SW gauges in them but they were paintcan lid style.
Chuck Lutz
GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
Bantam T3-C 1947
GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
Bantam T3-C 1947
Who is online
Users browsing this forum: No registered users and 35 guests