FS 1945 Converto T6 restored trailer

Quarter-ton trailer series, Wanted, USED PARTS FOR SALE NO EBAY or COMMERCIAL SALES., and Knowledge Base
Post Reply
Ern Stacey
Staff Sergeant
Staff Sergeant
Posts: 197
Joined: Sun Nov 30, 2003 5:14 pm
Location: South West Wyoming

FS 1945 Converto T6 restored trailer

Post by Ern Stacey » Sun Sep 24, 2017 10:00 am

Rare 1945 Converto T6 1/4 ton trailer for sale. The trailer has been fully restored in the Lusterless Navy Gray color. When restoring I took considerable time to sand down through layers of paint to find and retain what original markings were on the trailer. Once the markings were uncovered I took measurements and used onion skin paper to trace the markings to get them back in the original spot once the trailer was restored. After working down to the primer I sand blasted to bare metal before priming and repainting.
I purchased the trailer from the wife of the original owner who had passed away. The original owner was an engineer with the Navy Department when he purchased it in 1947. Like most of these trailers he removed the back panel and turned it into a tailgate. But like a lot of people he did not cut the Lunette but built a bracket using it for pulling with a ball mount. The trailer is very straight with very few dings or dents, and has minimal waving in the floor. There was just surface rust here and there due to the fact it was stored most of the time in his garage. I replaced the rear panel, but did not make it water tight, using small metal straps bent in a L shape and spot welded to floor and panel, (I have pictures if you would like to see them). After sand blasting I put 2 coats of Automotive grade etching primer on the bare metal with 4 coats of Gillispie Lusterless Navy gray over the primer.
The trailer had quite a few original parts on it when purchased. These include

Body and frame
Axle, hubs and backing plates along with all hardware
Thin Lunette
Lunette casting, swivel and landing leg
1 original chain with TP-2 in wedge and TH in cast hook
Both CB tail light covers---buckets were rusted through
4 KD# 333 reflectors with 4 holes
Original shocks
Brake Handle which is unique for this trailer
All original cable and hardware to brakes
Tail light mounting brackets

Non original parts purchased to restore this trailer include

Combat rims and tires
Cloth Covered wiring harness (purchased from Ron)
Blackout light switch (NOS)
Trailer to Vehicle cloth covered plug and wiring (4 wire NOS post war)
Light Buckets (NOS)
Gray Canvas cover and ropes (Beachwood canvas)
1 Early M100 trailer chain with cast hook TP-2 on wedge and a stamped TH in hook (do not believe it is from factory)
Beachwood protective cover made out of heavy vinyl to protect trailer while in storage in garage

Since restoration this has been kept in garage with cover on it, except when taken to shows and pulled behind the jeep.
Asking $2000 or Best Offer that is reasonable. Please PM me if you would like to see more pictures.
Attachments
IMG_1946.JPG
IMG_1946.JPG (52.05 KiB) Viewed 567 times
IMG_1938.JPG
IMG_1938.JPG (45.48 KiB) Viewed 567 times
IMG_1939.JPG
IMG_1939.JPG (66.03 KiB) Viewed 567 times
IMG_1950.JPG
IMG_1950.JPG (82.38 KiB) Viewed 567 times
IMG_1951.JPG
IMG_1951.JPG (88.2 KiB) Viewed 567 times
IMG_1949.JPG
IMG_1949.JPG (83.31 KiB) Viewed 567 times

Chuck Lutz
Gee Addict
Posts: 23919
Joined: Wed Jun 28, 2006 8:00 am
Location: Novato, CA

Re: FS 1945 Converto T6 restored trailer

Post by Chuck Lutz » Sun Sep 24, 2017 6:00 pm

Anyone contemplating owning an original WWII trailer should pay attention here....the cost of the bolt-on parts these days is pretty high. Add the rims, tires, BO switch, handbrake, landing leg, lunette, taillight buckets, reflectors, harness, paint, bearings ad sandblasting to the cost of a candidate you find elsewhere that will still cost from maybe $900 to $1200 and you can exceed the cost of this one without your sweat equity involved.

Hey, you can always paint it OD if that's your thing, but that won't cost ya much....this is a VERY reasonable price in my estimation.
Chuck Lutz

GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
GPW 108552 4/17/43 Louisville, KY. USA 20371278 (DOD est./Tom W.)
Bantam T3 4582 10/29/42 USA 0173499 (est.)

TonyStandefer
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 384
Joined: Sun Apr 18, 2004 3:43 pm
Location: Everett, Wa
Contact:

Re: FS 1945 Converto T6 restored trailer

Post by TonyStandefer » Sun Sep 24, 2017 6:50 pm

I agree with chuck, a bargain price for a nice wartime trailer. I am in the process of re painting and refurbing a trailer. I have spent 100.00 for paint and primer, probably another 20-30 in materials, tires, tubes 300.00. Brake cable 100.00. Tail lights and reflectors, 150.00canvas cover 100.00. Etc.
Willys MB 340931. DOD 6-9-1944
Mvpa 1996 convention 1st place motorpool class

Leo H Jankowski
G-Colonel
G-Colonel
Posts: 1213
Joined: Thu Jul 10, 2003 5:13 pm

Re: FS 1945 Converto T6 restored trailer

Post by Leo H Jankowski » Mon Sep 25, 2017 10:18 pm

Fantastic Navy trailer. And original markings too. What a find. Best wishes; Leo

Ern Stacey
Staff Sergeant
Staff Sergeant
Posts: 197
Joined: Sun Nov 30, 2003 5:14 pm
Location: South West Wyoming

Re: FS 1945 Converto T6 restored trailer

Post by Ern Stacey » Tue Oct 17, 2017 5:15 am

Price reduced to $1750


Bart1015
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 284
Joined: Wed Apr 16, 2014 7:20 pm

Re: FS 1945 Converto T6 restored trailer

Post by Bart1015 » Thu Oct 19, 2017 10:09 pm

I have no idea why this has not sold yet. Its a great looking trailer at an awesome price. If I was not several states away this would be mine.

Good luck with your sale.

Brett
1942 Matching numbers GPW, capstan winch, BC-659
1945 GPW in progress
1943 Bantam trailer
1967 M151a1/M416 - Sold

Post Reply

Return to “Trailers 1/4 ton”

Who is online

Users browsing this forum: Google Adsense [Bot] and 2 guests