205 Bearing puller
-
- G-Master Sergeant
- Posts: 121
- Joined: Tue Feb 06, 2018 12:59 pm
- Location:
205 Bearing puller
Anyone know what the best or preferred tool for removing the "205" bearing? I have the rear transmission cover off and I have a new bearing so I guess now is the time to change it. The inboard side face of the bearing has rust but otherwise the bearings seems to be fine.
-
- G-First Lieutenant
- Posts: 646
- Joined: Mon May 14, 2007 5:36 pm
- Location: Georgia
- Contact:
Re: 205 Bearing puller
Depending on the bearing location:
Intermediate Gear with bearing on Gear Shaft use a 3 jaw bearing puller or bearing puller and press off. Bearings in Transmission Cover secure bearing retainer with 2 nuts and drive out bearing with a socket or punch.
Intermediate Gear with bearing in bottom of transmission use a 2 jaw set for inside grip or a blind hole bearing puller.
Try this blind hole bearing puller from Harbor Freight includes the slide hammer
https://www.harborfreight.com/slide-ham ... 62601.html
Three Jaw
https://www.harborfreight.com/3-jaw-pil ... -4876.html
Bearing Puller
https://www.harborfreight.com/large-bea ... -3979.html
Intermediate Gear with bearing on Gear Shaft use a 3 jaw bearing puller or bearing puller and press off. Bearings in Transmission Cover secure bearing retainer with 2 nuts and drive out bearing with a socket or punch.
Intermediate Gear with bearing in bottom of transmission use a 2 jaw set for inside grip or a blind hole bearing puller.
Try this blind hole bearing puller from Harbor Freight includes the slide hammer
https://www.harborfreight.com/slide-ham ... 62601.html
Three Jaw
https://www.harborfreight.com/3-jaw-pil ... -4876.html
Bearing Puller
https://www.harborfreight.com/large-bea ... -3979.html
Mules are my passion
www.m274armymules.com
www.m274armymules.com
Who is online
Users browsing this forum: No registered users and 20 guests