Need help Carter YS 950

1952 - 1968, M38A1, M170, questions, discussions, regarding anything related to the M38a1 series.
swampy
G-Sergeant
G-Sergeant
Posts: 34
Joined: Sat Nov 12, 2016 2:00 pm

Re: Need help Carter YS 950

Post by swampy » Sun Dec 31, 2017 1:21 pm

it gets rich turning counter clockwise, and lean turning clockwise lolSeriously though, i have installed a new kit from John@ Midwest Mil, found a nice old stock upper(aluminum part above throttle body) some of my screw holes were stripped on my old carb body} Still cannot figure why it will not run w/o having the choke pulled out a ways.......One could surmize this being my first rodeo, but far from it. i have had several A1s over the years and many wrench turning years of experience on all of them, M38, as well as civvyies there were no vacuum leaks berore the rebuild, no are there any now.

Post Reply

Return to “M38a1 Technical Knowledge Base”

Who is online

Users browsing this forum: No registered users and 1 guest