I’m looking for help as to the requirement of needing one to what value is the resistor?
I’m installing a Petronics 24 volt electronic ignition into a stock distributor.
Ballast Resistor - 24 volt
- EME-LT
- G-Sergeant
- Posts: 31
- Joined: Tue Feb 04, 2014 3:26 pm
- Location: Vancouver, BC
Ballast Resistor - 24 volt
Cheers, Lyle
Arte et Marte
Arte et Marte
- EME-LT
- G-Sergeant
- Posts: 31
- Joined: Tue Feb 04, 2014 3:26 pm
- Location: Vancouver, BC
Re: Ballast Resistor - 24 volt
I spoke with Petronix, as I am installing the 24v version of electronic point replacement.
They require 4-5 volts to the sensor/pick-up.
assuming (and you should check) that the NOS 24 coil has 3 ohm internal resistance; A 3 ohm ballast resistor is required....
24/6 equals 4 volts........
They require 4-5 volts to the sensor/pick-up.
assuming (and you should check) that the NOS 24 coil has 3 ohm internal resistance; A 3 ohm ballast resistor is required....
24/6 equals 4 volts........
Cheers, Lyle
Arte et Marte
Arte et Marte
Who is online
Users browsing this forum: No registered users and 30 guests